Skip to content

How to Prepare Pages for Landscape Printout

Note: Because these instructions are exclusive to dvips, they are not applicable to PDFLaTeX submissions, which produce PDF directly and do not follow the LaTeX-->DVI-->PostScript-->PDF conversion path.

If you have a wide table or other material that should be printed in landscape mode, you should follow the instructions given in the dvips info pages. For your convenience, we appended the two relevant sections from the dvips documentation.

Before you go on, however, be warned that the standard paper size in the US is letter, which is shorter than A4 paper, i.e., less wide in landscape mode, and that your landscape documents need to be tuned to properly fit on letter paper. Otherwise text may be truncated when printed in the US.

Note also that there are different conventions as to which way to rotate pages, and this (apart from being upside down on screen) affects the margins. Always check the postscript we generate here and make adjustments as necessary.

Paper Size and Landscape Orientation

Although most TeX documents at a particular site are designed to use the standard paper size (letter size in the United States, A4 in Europe), the dvips program can be customized, either site-wide or for a particular printer.

Many documents are designed for other paper sizes. For instance, you may want to design a document that has the long edge of the paper horizontal. This can be useful when typesetting booklets, brochures, complex tables, or many other documents. This type of paper orientation is called "landscape" orientation (the default orientation is "portrait"). Alternatively, a document might be designed for ledger or A3 paper.

Since the intended paper size is a document design decision, not a printing decision, such information should be given in the TeX file and not on the dvips command line. For this reason, dvips supports a papersize special. It is hoped that this special will become standard over time for TeX previewers and other printer drivers.

The Papersize Special

The format of the papersize special is:

     \special{papersize=WIDTH,HEIGHT}

WIDTH is the horizontal size of the page, and HEIGHT is the vertical size. The dimensions supported are the same as for TeX; namely, in (inches), cm (centimeters), mm (millimeters), pt (points), sp (scaled points), bp (big points, the same as the default PostScript unit), pc (picas), dd (didot points), and cc (ciceros).

For a US letter size landscape document, the papersize would be:

     \special{papersize=11in,8.5in}

An alternate specification of landscape:

     \special{landscape}

is supported for backward compatibility, but it is hoped that eventually the papersize comment will dominate.

Of course, such a \special only informs dvips of the desired paper size; you must also adjust \hsize and \vsize in your TeX document typeset to those dimensions.

The papersize special must occur somewhere on the first page of the document.

How to Pass a Papersize Flag to our Postscript Generator

If for some reason the method described above does not work for you, all hope is not lost. You can alternatively pass a landscape flag to our automated postscript generator to be used by dvips.

Example

Suppose you have TeX source for some wide tables that were prepared to be printed in landscape mode; let's call them mywidetable1.tex and mywidetable2.tex. On your local system, these can be processed with:

     $ dvips -t landscape mywidetable1.dvi
     $ dvips -t landscape mywidetable2.dvi

On our system, this can be accomplished by including a file with special instructions for our postscript generator in your submission. This file has to be called 00README.XXX — the filename has to be all uppercase, it starts with two zeros, and it has to be in the top level directory of your submission. In our example, 00README.XXX should contain one line for each table to be processed with the landscape flag:

     mywidetable1.dvi landscape
     mywidetable2.dvi landscape

Note that the file extensions are .dvi (not .tex) because the instruction applies to the dvi to ps stage, not to the tex to dvi stage.